Arduino CNC Shield for Stepper Motor
- Arduino UNO shield form factor, compatible with Arduino UNO.
- GRBL v1.1 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals)
- Uses removable A4988 compatible stepper drivers (Not Included)
- PWM Spindle and direction pins
- 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins A4 and A3)
- 2 x End stops for each axis (6 in total) + one Probe
- Coolant enable output
- Jumpers to set the Micro-Stepping for the stepper drivers.
- Stepper Motors can be connected with 4 pin connectors or soldered in place.
- Runs on 12-35V DC. (Depending on Stepper driver
TB6600 Stepper Motor Driver Controller 4A 9-42V TTL CNC
- easy-to-use professional stepper motor driver
- Support 8 kinds of current control
- Support 7 kinds of micro steps adjustable
- The interface adopts high-speed optocoupler isolation
- Automatic semi-flow to reduce heat
- Large area heat sink
- Anti-high-frequency interference ability
- Input anti-reverse protection
- Overheat, over current and short circuit protection