Phone: +977-9860563506, +977-9860308141, +977-9841223274 | Email: slighttech@gmail.com

Servo Motor Driver Board

  • Category : Robotics And Electronics
  • Sub Category : Motors & Motor Drivers
  • Status : In Stock

Ask For Price

Product Details

- A product for Arduino that works with official Arduino boards. 

- This is a i2c-controlled PWM driver board with a built-in clock? which is quite different from TLC5940 series. You don’t need to continuously send signals and occupy your MCU.

- 5V compatibility, which means that you can use 3.3V MCU to control and drive the output up to 6V (when you want to control the white or blue indicator light, 3.4V+ is also OK).

- 6 address select pins allow you to connect 62 driver boards to one i2C bus, total 992 channels of PWM output.

- About 1.6KHz frequency modulation PWM output.

- Get 12-bit resolution output ready for stepping motor, which means that the 60Hz update rate can reach to 4us resolution.

- Configurable totem-pole output or open-collector output.

- Output enable pin can quick disable all outputs.

- PCA9685 chip is at the center of the board.

- With power input terminal.

- With green power indicator light.

- Convenient to insert total 16 servos at the same time (the plug of servo is a little large than 0.1", so you can put 4 pairs of 0.1" connectors).

- With reverse polarity protection for input.

- Cascade design.

- Put a bulky capacitor on the V+ line (sometimes you need it).

- Put 220 ohm resistance components onto all PWM output lines, so as to protect them, and you can easily drive the LED.